Lamp Sequencer | LM393 | Arduino

          Howdy, today we are going to do the Lamp Sequencer project which takes sound as input and respond to it. It's easy, funny and lovely. Let's get started.

Hardware Required

Arduino IDE

Wiring Diagram

Let connect the peripherals as described in the table below
Pin outs
Note: If you are using 5V relay, the above pin out is acceptable. If you are using (12 or 24)V relay, Use separate (12 or 24)V DC supply and do common ground.

Looks sick 😊

Schematic

Let's code 💪

          Uff.. It's time to code our controller board. This is pretty long here due to sequence switching. But don't worry. Copy paste the code in your Arduino IDE. After done it, compile check and upload the program. Ensure you have selected the specified board and port.

IDE-Code

Prototype GIF

GIF

Thank you
Issues, suggestions, complaints: Drop mail

Comments

Popular posts from this blog

A2XWY; A2XFY Cables meaning; XLPE cables advantages over PVC cables

Digital Multimeter working principle; DMM working

Wireless voltmeter using Arduino and RF 433MHz receiver and transmitter